Reaver参数大全-想要PJ就要多看看这个早晚你会用到.doc

必须参数-i, --interface=wlan Name of the monitor-mode interface to use网卡的监视接口，通常是mon0-b, --bssid=mac BSSID of the target APAP的MAC地址Optional Arguments: 可选参数-m, --mac=mac MAC of the host system指定本机MAC地址-e, --essid=ssid ESSID of the target AP路由器的ESSID，一般不用指定-c, --channel=channel Set the 802.11 channel for the interface (implies -f)信号的频道，如果不指定会自动扫描-o, --out-file=file Send output to a log file [stdout]输出日志文件-s, --session=file Restore a previous session file恢复进度文件-C, --exec=command Execute the supplied command upon successful pin recoverypin成功后执行命令-D, --daemonize Daemonize reaver设置reaver成Daemon-a, --auto Auto detect the best advanced options for the target AP对目标AP自动检测高级参数-f, --fixed Disable channel hopping禁止频道跳转-5, --5ghz Use 5GHz 802.11 channels使用5G频道-v, --verbose Display non-critical warnings (-vv for more)显示不重要警告信息 -vv 可以显示更多-q, --quiet Only display critical messages只显示关键信息-h, --help Show help显示帮助Advanced Options:高级选项-p, --pin=wps pin Use the specified 4 or 8 digit WPS pin使用指定的4位或者8位pin码-d, --delay=seconds Set the delay between pin attempts [1]pin间延时，默认1秒-l, --lock-delay=seconds Set the time to wait if the AP locks WPS pin attempts [60]AP锁定WPS后等待时间-g, --max-attempts=num Quit after num pin attempts最大pin次数-x, --fail-wait=seconds Set the time to sleep after 10 unexpected failures [0]10次意外失败后等待时间，默认0秒-r, --recurring-delay=x:y Sleep for y seconds every x pin attempts每x次pin后等待y秒-t, --timeout=seconds Set the receive timeout period [5]收包超时，默认5秒-T, --m57-timeout=seconds Set the M5/M7 timeout period [0.20]M5/M7超时，默认0.2秒-A, --no-associate Do not associate with the AP (association must be done by another application)不连入AP（连入过程必须???其他程序完成）-N, --no-nacks Do not send NACK messages when out of order packets are received不发送NACK信息（如果一直pin不动，可以尝试这个参数）-S, --dh-small Use small DH keys to improve crack speed使用小DH关键值提高速度（推荐使用）-L, --ignore-locks Ignore locked state reported by the target AP忽略目标AP报告的锁定状态-E, --eap-terminate Terminate each WP