h何新云非人力资源经理的人力资源管理.doc

非人力资源经理的人力资源管理 【背景介绍】 企业最重要的资产是人，在企业中真正从事人力资源管理工作的管理者是各个直线部门的主管，无论是从人才的甄选、培育、使用，到留住人才，都是由直线部门的执行的。因此，让直线部门的主管了解人力资源管理是十分有必要的。本课程正是针对特别设计和规划何新云：组织及人力资源管理专家，资深管理咨询顾问，国内知名培训讲师，先后获得数学学士和工商管理硕士学位，拥有超过年的企业经验和管理经验曾任职于华为、金蝶等知名企业何先生在授课过程中经验，咨询客户：宁波方太厨具有限公司、培训客户：何先生在授课过程中善于分享亲身工作的实际操作经验， position for future reference. Installation using special lifting pole rotor 6.4.4.6 rotor lift, box spirit level to check the rotor axis neck of Yang, on both sides of the rotor should be lateral raises and numerical deviation of ≤ 0.10MM, qualified before the official lifting. Hoisting of the rotor dynamic and static clearance should be measured, rotors check clearance to prevent rotor colliding. 6.4.4.7 stationary blade carrier, diaphragm and sealing upper cylinder on the inside and install the mounting bolts, bolts and bolt holes in the surface should be coated with molybdenum disulfide. Follow the manufacturers stamp marked to install good sealing ring and spring. Check the sealing ring and spring plate, shall conform to the technical requirements manufacturers drawings. Bolt: ... Measurement with measurement tools, special tools, temporary connection bolts and connection tool equipped and in good condition. The rotor shaft to have fixed, such as thrust, bearing plates fixed installation, in case of wear of the rotor is too large. The coupling gasket check measurements: measured data processing according to gasket, clean the coupling gasket surface clean and Burr-free, check the coupling gasket thickness data, shim thickness deviation of ≤ 0.02mm, parallel degree deviation of ≤ 0.02mm. Coupling temporary bolts ready: preparing 4-8 bolt diameter coupling bolt hole diameter 0.5-1.0mm. 6.4.5.2 shaft coupling 6.4.5.2.1 General requirements in both the relative position of the flange according to the manufacturers mark, if there is no mark, two flange scoop bias complement each other and take care of the bolt hole alignment, hit the mark as basis for alignment and coupling is fi