物流管理课程设计任务书第十周之前.doc

物流管理课程设计任务书 主讲教师:李翔 余波 一、课程设计名称 课题A：城市配送车辆限行方案设计 结合绵阳城市道路交通布局、企事业单位与居民小区、商业网点及物流园区分布情况给出绵阳城市配送车辆限行方案，以提高绵阳城市配送集约化水平，规范绵阳城市道路交通秩序，减少城市道路交通拥堵与环保压力。 课题B：行业物流资源整合方案设计 结合绵阳具体情况，任选择2--3个行业，给出行业物流资源整合、共享，实现跨界发展、联动经营的操作方案，旨在减少城市物流与土地资源浪费，有效降低资源利用率不足、物流成本居高不下等顽症。 课题C：第五届全国大学生物流设计大赛案例设计 结合第五届全国大学生物流设计大赛案例，任选择2--3个方向，给出设计方案。 二、课程设计的目的 物流管理课程设计是物流管理专业的重要实践性教学环节，是综合运用所学专业知识，对实际物流管理对象进行物流系统的问题诊断开展的一次综合性训练。使学生对物流学科相关知识的综合应用能力得以提高，提高学生分析，判断及解决实际问题的能力。 or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3) pipe supports and hangers part plant product quality certificate for each variable spring supports, constant support hangers, dampers, damper function, there should be factory calibrated test and performance test copies of the record. If necessary, review should be1 or equal to 200