现代物流课程论文中小型企业现代物流管理的现状及改善措施.doc

现代物流概论 课程论文 题 目: 中小型企业现代物流管理 的现状及改善措施 院系名称： 生物工程学院 专业班级： 生物工程1210班 学生姓名： 程文龙 学 号： 201212911006 中小型企业现代物流管理的 现状及改善措施 摘要：近年来我国企业管理已经取得了长足的进步成本实现可持续发展目标创造了有利条件。因此要进一步提高物流成本管理水平必须在政府的扶持和指导下。通过各方的共同努力我国企业的物流成本管理水平定会有所突破为现代化建设和“中国梦”的实现贡献力量。 or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3) pipe supports and hangers part plant product quality certificate for each variable spring supports, constant support hangers, dampers, damper function, there should be factory calibrated test and performance test copies of the record. If necessary, review should be or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending produc