Co-simulation in SCM Teaching.doc

Co-simulation in SCM Teaching Abstract: This paper describes the use of Proteus software and Keil uVision3 simulation software to establish a joint approach and use examples of co-simulation methods and processes. Keywords:: Proteus software; Keil uVision3 Software At present, the SCM technology in the actual project has been widely used, Proteus software and Keil uVision3 software co-simulation in the actual MCU system development has been widely used. To this end, the teaching process in SCM curriculum, teachers must be practical to do with engineering software and hardware combination of theoretical teaching and engineering practice to achieve close integration of theoretical knowledge in imparting the same time, teach students how to use the practical application of the relevant works SCM software system development. Proteus software and Keil uVision3 Software Description Proteus Software Introduction Proteus software is developed by the British LabcenterElectronics of electronic design automation (EDA) tools. The software is achieved mainly by the schematic editor and simulation of the ISIS module and achieve the PCB board design and automatic layout of the ARES module. Proteus not only of other EDA software, analog electronics and digital electronics simulation, but also of other EDA software is not hardware emulation function of SCM System. It can simulate the MS51 series of microcontrollers, AVR Microcontroller, PIC microcontroller and ARM7 microprocessor in the circuit diagram can be directly implemented on the hardware of the virtual simulation, to achieve program debugging, and to provide testing and analysis of virtual oscilloscope, logic analyzer, etc. Virtual Instruments and simulation diagrams. Keil uVision3 Software Keil uVision3 presentation software, is a German manufacturer of embedded development tools for the professional Keil microcontroller development, developed software platform. First of all, the software can not only software e