OracleSolaris11.3Network.PDF

Oracle Solaris 11.3 Network Administration Cheatsheet This cheatsheet includes examples of common network administration commands. For complete details, see the dladm(1M), ipadm(1M), and route(1M) man pages. Commonly Used Network Administration Commands Note - Some of following commands include parameters and values that are provided as examples only. Action Command Administering Profiles List all of the network profiles on a system. # netadm list Switch to the fixed mode by enabling the DefaultFixed profile. # netadm enable -p ncp DefaultFixed Administering Datalinks Display all of the datalinks (physical and virtual) on a system. # dladm show-link Display all of the physical datalinks on a system. # dladm show-phys Display all of the properties for all of the datalinks on a system. # dladm show-linkprop Display all of the properties for a specific datalink on a system. # dladm show-linkprop net0 Display a specific property for a specific datalink on a system. # dladm show-linkprop -p mtu net0 Administering IP Interfaces and Addresses Display general information about a systems IP interfaces. # ipadm Display a systems IP interfaces and addresses. # ipadm show-addr Create an IP interface and then configure a static IPv4 address for that interface. # ipadm create-ip net0 # ipadm create-addr -a 10.9.8.7/24 net0/addr Obtain an IP address from a DHCP server. # ipadm create-ip net0 # ipadm create-addr -T dhc