现浇砼板模板工程技术交度.doc

现浇砼板模板工程技术交度 现浇砼板模板工程技术交度作者：佚名 时间：2017-1-3 浏览量： 一.工程名称: 二.分部工程:主体 三.分项工程名称:现浇砼板模板工程 四.交底内容: 、木模板厚度-般应在25-50mm之间,或用组合钢模板。 2、所有支撑应牢固,应保证模板有足够的刚度、强度和稳定性。 3、地面夯实→支立柱→安大小龙骨→铺模板→校正标高→加立杆的水平拉杆→办预检。 4、土地面应夯实,并垫通长脚手板,楼层地面立支柱前也应垫通长脚手板。采用多层支架支模时,支柱应垂直,上下层支柱应在同一竖向中心线上。 5、从边跨一侧开始安装,先安第一排龙骨和支杆,临时固定,再安第二排龙骨和支柱,依次逐排安装。支柱与龙骨间距应根距模板设计规定。一般支柱间距为80-120cm,大龙骨间距为60-120cm,小龙骨间距为40-60cm。 6、调节支柱高度,将大龙骨找平。 7、铺定型组合钢模板块:可从一侧开始铺,每两块板间边肋用U形卡连接,U形卡安装间距一般不大于30cm。每个U形卡卡紧方向应正反相间,不要安在同一方向,楼板在大面积均应采大尺寸的定型组合钢模板块,在拼缝处可用窄尺寸的拼缝模板或木板代替,但均应拼缝严密。 8、平台板铺完后,用水平仪测量模板标高,进行校正,并用靠尺找平。 9、标高校完后,支柱之间应加水平拉杆,根据支柱高度决定水平拉杆设几道。一般情况下离地面20-30cm处一道,往上纵横方向每隔左右一道,并应经常检查,保证完整牢固。 0、将模板内杂物清理干净,办预检。 技术负责人: 交底人: 接受人: Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excellent moral education curriculum system a