电梯井筒模板施工方法.doc

电梯井筒模板施工方法 电梯井筒模板施工方法提要：筒模四角都调到垂直位置后，用四道横向方钢龙骨围拢，在用方钢管卡子--固定，使铰接筒模成为一个刚性的整体 更多精品源自试题 电梯井筒模板施工方法 1、工艺流程 （1）模板拼装 下部模板拼装→对角线找方→上部模板拼装→安装纵横龙骨→安装脱模器→安装其它零部件→刷脱模剂 （2）模板安装及脱模 2、收缩筒模→起吊入模→就位调整→安装定型板→紧固穿墙螺栓→浇筑砼→拆除穿墙螺栓及定型板→收缩脱模→吊出筒模→清理刷脱模剂→再次使用 3、操作要点 （1）工程上直接拼装筒模时，基层应处理平整，事先放出模板位置线。 （2）筒模四角都调到垂直位置后，用四道横向方钢龙骨围拢，在用方钢管卡子--固定，使铰接筒模成为一个刚性的整体。 4、筒模构造示意图如下： 筒示意图 1-花篮螺栓脱模器；2-铰链角模；3-模板；4-方钢横龙骨；5-方钢纵龙骨 电梯筒模构造示意图 5、模板施工注意事项 （1）严格控制柱顶标高（误差不超过±10mm），模板安装必须严格按模板设计施工，模板相邻高差不超过3mm，所有节点必须逐个检查是否拧牢卡紧。 （2）模板在使用前，均刷脱模剂，使用后及时清理归堆备用。 （3）严格控制模板和立柱脱模时间，顶模板待砼强度达到规范要求方可拆除。 （4）模板的装拆和运输应轻放，严禁摔砸，严格控制施工荷载，上料要分散堆放，在支撑过程中必须先将一个网格的水平支撑及斜撑安装好的，再逐渐向外安装，以保证支撑系统在安装过程中的稳定性。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excellent m