恒强系统维修方法(国外英文资料).doc

恒强系统维修方法(国外英文资料) Machine troubleshooting method The needle is divided into knitting needles and needles Knitting needle leakage: A bad needle (needle, tongue, etc.) The brush is properly installed and is hollowed out for long term use The veil is too high or too wide The border line has a weak line The density is too loose, the needle is made into a coil and then the coil can be lowered Needles randomly picked There is not enough tension in the roll, and the sheets float Double needle leakage: Bad needle Fine-tune the bed of the needle The needle butterfly mountain is too low The needle is not selected by the needle, the needle is not selected, the needle is not moved, the value is too large, and the switch is stuck The needle is stuck in the needle, and the clip is blocked by the needle Density is too tight If the needle is not given, the pin should be removed The weaving tension should be appropriate, the tension should be as small as possible, usually between 0 and 5, The needle is not high enough to be retested The bad side, the edge The gauze mouth is too narrow, too wide, too high, too low, the yarn mouth to eat the yarn to have the deviation The edges are too weak or too strong The density is too tight and the edges are loose and the edges of the knitting are not enough The yarns overlap When the nose is turning, the brush hooks up to the line The high needle causes the margin The needle and the handling plan Analysis of the cause of the crash: The bad needle, the baotou needle causes the float Laura does not turn the float The triangle has no card to die No card dies There is no foreign body in the mountain board Its not enough to grind the needle There is a pin on the pin The gap between the pin plate and the mountain plate is large, usually 20 to 35S The needle butterfly mountain was too low, and the needle was shot The needle is removed and the spring needle is not pressed into the needle Improper operation and no saving of waste yarn The needle handling