179-AS1359.0_1998-旋转电机—一般性要求第0部分：各部分列表说明.doc

Australian StandardTM 澳大利亚标准TMRotating electrical machines—General requirements 旋转电机—一般性要求 Part 0: Introduction and list of Parts 第0部分：各部分列表说明 This Australian Standard was prepared by Committee EL/9, Rotating Electrical Machinery. It was approved on behalf of the Council of Standards Australia on 2 July 1998 and published on 5 September 1998. 本澳大利亚标准由旋转电机EL/9委员会编制，以澳大利亚标准委员会的名义于1998年7月2日获得审批通过，并于1998年9月5日出版。 The following interests are represented on Committee EL/9: EL/9委员会由下列单位参加： Australian British Chamber of Commerce 澳大利亚—英国商会 Australian Electrical and Electronic Manufacturers Association 澳大利亚电子电工制造商协会 Bureau of Steel Manufacturers of Australia 澳大利亚钢铁制造局 Confederation of Australian Industry 澳大利亚工业联盟 Department of Defence 国防部 Electricity Supply Association of Australia 澳大利亚供电协会 Review of Australian Standards. To keep abreast of progress in industry, Australian Standards are subject to periodic review and are kept up to date by the issue of amendments or new editions as necessary. It is important therefore that Standards users ensure that they are in possession of the latest edition, and any amendments thereto. 澳大利亚标准的评审。为了保持标准与工业发展同步，澳大利亚标准需要定期进行评审并发布修订本，必要时出版新的版本以保持更新。因此，标准使用者使用的版本必须是必威体育精装版版本，同时需要使用所有修正版本的内容。 Full details of all Australian Standards and related publications will be found in the Standards Australia Catalogue of Publications; this information is supplemented each month by the magazine ‘The Australian Standard’, which subscribing members receive, and which gives details of new publications, new editions and amendments, and of withdrawn Standards. 澳大利亚标准局出版的《标准目录》收集了所有标准的详细信息和相应出版物，此信息每月在杂志《澳大利亚标准》上进行补充说明，已订阅会员会收到此杂志，另外该杂志还会介绍新出版物、新版本和修订本以及废止标准的详细信息。 Suggestions for improvements to Australian Standards, addressed to the head office of Standards Australia, are welcomed. Notification of any inaccuracy or ambiguity found in an Australian Standard should be made without delay in order that the matter may be investigated and appropriate action taken. 我们欢迎