发电机维修颐养资料(国外英文资料).doc

发电机维修保养资料(国外英文资料) Applicable to the standby generator set maintenance scheme (such as residential area, building, hospital, office unit, scenic spots, such as factory power outages, rarely used only for fire control, power cut overhaul time, only with the standby generator set) Routine maintenance: on the basis of daily maintenance, once every six months or once a year Conduct a thorough examination of water, electricity, oil and gas in the generator set, and make sure that the unit is normal; 5-10 minutes of empty test drive to allow the crew to be fully lubricated; Judge the use of the unit by listening, watching and smelling; Change air filtration, diesel filter, oil, oil, water filtration, oil and water separator, etc. 4, replace cooling water tank coolant, water tank treasure; Add battery battery or distilled water. After the maintenance is completed, the unit is inspected again and cleaned and cleaned. 5-10 minutes of empty test machine, record the performance parameters of the unit, provide reasonable suggestion and customer acceptance. Suitable for long-term operation of generator set maintenance scheme (such as construction sites, often power plant, transformer load enough, project test, can not pull the mains, etc., often need to run continuously or generator) Primary technical maintenance: (50-80 hours) increases in the content of daily maintenance Clean air cleaner and replace when necessary; 2, replace diesel filter, air filter, water filter; Check the tension in the driving belt; Lubricate all the oil filling and lubricating parts. Replace cooling water Secondary technical maintenance: (250-300 hours) increases in the content of daily maintenance and primary maintenance Clean piston, piston pin, cylinder liner, piston ring, rod bearing and check for wear and tear. Check the inside and outside circles of the main bearing are not loose; Remove the scale and silt in the water system of the cooling water system; Remove the coals from the combustion chambe