屋面板装置细则1(国外英文资料).doc

屋面板安装细则1(国外英文资料) Eaves, mountain walls, deformation joints, joints, etc. Should be encrypted. The screw should be mounted perpendicular to the panel and must not be emptied. The screw must be removed and treated with glue for incorrect location. The waterproof cap of the screw must be glued to the surface of the screw The roof panel is fitted with the roof panel, the making model and the vertical transport equipment 2) the end of the roof of the roof of the roof is matched with the purline of the strip. 3) all of the planks position and arrangement in the building need to be 300mm modulus. 4) the fixed mode of roof pressure plate A: when the pressure plate is connected to the purline, the galvanized self-tapping screw with waterproof washer is fixed and fixed It should be located at the crest of the wave, the distance is equal to 350mm, and the connection to the same purline or wall shall not be less than 3 points. When fixed, the manual operation is moderate, it is not appropriate to hold the self-tapping screw tightly or too loose to prevent the formation of cracks. B: when the pressure plate is connected to the pressure plate, the pull rivets with the waterproof washer are fixed and the spacing of the rivets is 250mm. C: all the leakage of self-drilling screws and rivets shall be daub sealing material protection, such as sealing glue), and waterproof cap, exposed screw seal material protection. D: when laying the roof of the steel plate, the connecting two sides of the plate should be connected by the maximum frequency to avoid The cold air is poured indoors when the wind is blowing. Pressure type metal roof panel shall be length on the supporting component project Lap length (mm) Adjacent two compression metal plate (height greater than 70) 375 Adjacent two pressing metal plates meet the inner slope of the roof 1/10 250 The slope in the roof is greater than 1/10 200 The roof plate is connected to the panpan 200 The pan-water board on the roof of the steel plat