模板工程量计算(国外英文资料).doc

模板工程量计算(国外英文资料) The calculation of template engineering The types of basic components It is divided into independent foundation, cup foundation and manchu foundation. Strip foundation (no girder bar foundation, girder bar foundation), box form foundation The calculation of basic templates S = concrete and template contact area The area of contact area of S = concrete and the template is equal to the base set length of the length by the height of the set Solution 1. The analysis It can be seen that this foundation is based on the beam type, which is the base of the base plate (thick 200mm) and the two sides of the beam (high 300mm). Therefore, the area of the contact area of concrete and the template should be calculated: the area of both sides of the base plate and the area of the beam. Calculate the amount of work Exterior wall: Base plate S = (3.6 x 2 + 0.6 * 2) * 2 times 0.2 + (4.8 + 0.6 * 2) * 2 times 0.2 + (3.6-0.6 times 2) * 4 times 0.2 + (4.8-0.6 times 2) * 2 times 2 times 0.2 = 9.12 m? The base beam S = (3.6 x 2 + 0.2 times 2) times 2 times 0.3 + (4.8 + 0.2 times 2) times 2 times 0.3 + (3.6-0.2 times 2) times 4 times 0.3 + (4.8-0.2 times 2) * 2 times 2 times 0.3 = 14.16 m, right? Under the interior wall Base board S = (4.8-0.6 x 2) times 2 times 0.2 = 1.44 m? Base beam S = (4.8-0.2 times 2) * 2 times 0.3 = 2.64 m? Basic template engineering = 9.12 + 14.16 + 1.44 + 2.64 = 27.36 m? Were going to subtract the area of the inner wall in L 24 times 0.2 times 2 minus 1.2 times 0.2 times 2 is equal to 9.12 m2 24 times 0.3 times 2 minus 0.4 times 0.3 times 2 is 14.16 m2 The lateral column and the inner column The column height of the beam board shall be calculated from the upper surface of the cylinder or floor to the top floor The construction column template is calculated A letter of S = (d1 + 0.12) * 2 * h L, S = (d1 + 0.06) + (d2 + 0.06) + (0.06 by 2) S = [d1 + 0.12] + (0.06 x 4)] * h cross S = 0.06 times 2 times 4 times h Now cast concrete beam template The typ