模板施工3(国外英文资料).doc

模板施工3(国外英文资料) The construction plan of the large steel plate is set up According to the properties and structure characteristics of the project, through the selection, in many ways this project the ground structure of shear wall template choose 86 type shape steel template, the level of structure (beam) used bamboo laminating adhesive template, other types of template method has made a detailed description in section 7.3, this section is only finalize the design of construction scheme of large steel formwork are briefly introduced. Is characterized by high construction efficiency, strong integrity, stiffness big, large plates, flat-fell seam is little, pouring concrete quality is good, large capacity, high cycle utilization, satisfies the requirement of modern construction of economic durable, easy to operate. An overview of project 7.4.1 According to the existing tender drawings, the project 4 #, 6 #, 7 # residential main body structure of shear wall structure, middle elevator well, stair, main body wall thickness for 200, 250, 300, thus to finalize the large steel formwork design and construction. 7.4.2 template design 1) template structure (1) template structure design A, template design parameters: design side pressure F = 70KN/m2 B, template component material selection: C, panel. The template chooses t = 6mm thick steel plate, material Q235. D, left, right, lower border to choose 8 # Angle steel, upper border to choose 8 mm steel plate, material Q235. E, vertical rib. Choose 8 # channel steel, material Q235. F, horizontal keel. Use double 10 # channel steel, material Q235. (2) template structure: Large sheet of steel templates (see figure 1) A, vertical rib arrangement: 225 on both ends of the vertical rib arrangement is to first, and then from both ends to the middle spacing as n x 300 mm to decorate, remainder size in the middle (center remainder clearance size less than 380). B, the horizontal keel arrangement: the horizontal keel pair of 10 # the back of