VTP与VLAN配置.doc

应网友maochunfei55的要求，本篇文章是对《Packet Tracer 5.0建构CCNA实验攻略(3)——Cisco VTP》的详细补充。 图一　实验拓扑图 　　配置步骤：１、配置VTP协议Cisco 3560交换机配置命令，Cisco 3560交换机作为VTP Server，是局域网中的核心交换机。3560(config)#vtp domain senyaChanging VTP domain name from NULL to senya3560(config)#vtp server3560(config)#vtp mode serverDevice mode already VTP SERVER.查看VTP的配置3560#sh vtp statusVTP Version???????????????????? : 2Configuration Revision????????? : 4Maximum VLANs supported locally : 1005Number of existing VLANs??????? : 7VTP Operating Mode????????????? : ServerVTP Domain Name???????????????? : senyaVTP Pruning Mode??????????????? : DisabledVTP V2 Mode???????????????????? : DisabledVTP Traps Generation??????????? : DisabledMD5 digest????????????????????? : 0x51 0x27 0x1E 0xD3 0xC8 0x55 0xC1 0x58 Configuration last modified by 0.0.0.0 at 3-1-93 00:19:44Local updater ID is 192.168.1.254 on interface Vl2 (lowest numbered VLAN interface found) 　　两个作为接入\汇聚层的2950的配置VTP的命令2950A(config)#vtp domain senyaChanging VTP domain name from NULL to senya2950A(config)#vtp mode clientSetting device to VTP CLIENT mode.2950A(config)# 查看VTP的配置2950A#sh vtp statusVTP Version???????????????????? : 2Configuration Revision????????? : 4Maximum VLANs supported locally : 255Number of existing VLANs??????? : 7VTP Operating Mode????????????? : ClientVTP Domain Name???????????????? : senyaVTP Pruning Mode??????????????? : DisabledVTP V2 Mode???????????????????? : DisabledVTP Traps Generation??????????? : DisabledMD5 digest????????????????????? : 0x51 0x27 0x1E 0xD3 0xC8 0x55 0xC1 0x58 Configuration last modified by 0.0.0.0 at 3-1-93 00:19:44 　　２、配置trunk链路两个Cisco 2950交换机使用fastthernet0/24端口分别与核心交换机的24、23端口相连，这两条链 路应为trunk，相连的每个端口为trunk类型，配置命令相同，如下：2950B(config)#interface fa0/242950B(config-if)#switchport mode trunk2950B(config-if)#switchport trunk allowed vlan all 　　３、在核心交换机Cisco 3560上创建两个Vlan:vlan 2 名称为math；vlan 3名称为chinese。3560(config)#vlan 23560(config-vlan)#name math3560(config-vlan)#vlan 33560(con