无线905基于凌阳程序 调试成功 1602显示.doc

无线905基于凌阳程序 调试成功 1602显示 #include SPCE061A.h #include1602.h #define TxRxBuf_Len 4 unsigned int TxBuf[TxRxBuf_Len]= { 0x00,0x00,0x00,0x00 }; unsigned int RxBuf[TxRxBuf_Len]= { 0x00,0x00,0x00,0x00 }; ////////////////////////////////////////////////////////////////// #define BYTE_BIT7 0x0080 //---------------------------------------------------------------------------------------------------------------- unsigned int DATA_BUF; #define DATA7 ((DATA_BUFBYTE_BIT7) != 0) //----------------------------------------------NRF905控制IO------------------------------------------------------ #define TXEN IOB0 #define TRX_CE IOB1 #define PWR IOB2 //----------------------------------------------NRF905 SPI接口--------------------------------------------------- #define MISO IOB12 #define MOSI IOB4 #define SCK IOB5 #define CSN IOB6 // 数码管控制灯位定义 #define LED1 IOB8 #define LED2 IOB9 #define LED3 IOB10 #define LED4 IOB11 #define KEY1 IOA11 #define KEY2 IOA10 #define KEY3 IOA9 #define KEY4 IOA8 //----------------------------------------nrf905状态标志--------------------------------------------------------- #define AM IOB13 #define DR IOB14 #define CD IOB15 //--------------------------------------------------------------------------------------------------------------- unsigned int tf; //-------------------------------------------------------nrf905控制指令------------------------------------------- #define WC 0x00 #define RC 0x10 #define WTP 0x20 #define RTP 0x21 #define WTA 0x22 #define RTA 0x23 #define RRP 0x24 //------------------------------------------------NRF905寄存器配置------------------------------------------------ unsigned int RFConf[11]= { 0x00, //配置命令// 0x4c, //CH_NO,配置频段在430MHZ 0x0c, //输出功率为10db,不重发，节电为正常模式 0x44, //地址宽度设置，为4字节 0x04,0x04, //接收发送有效数据长度为