【2017年整理】毕业设计——基于单片机人体反应速度测试仪.doc

沈阳工学院 毕业设计报告 题 目：基于单片机人体反应速度测试仪 院 系： 信息与控制学院 （黑三） 专 业： 通信工程 （黑三） 班级学号： 093041 07 （黑三） 学生姓名： 张 三 （黑三） 指导教师： （黑三） 成 绩： 2014 年 06 月 25日 摘 要 本文是基于单片机人体反应速度测试描述，通过单片机测试人的反应速度。在本设计中以AT89S52单片机为核心的人体反应速度测试仪，主要控制测试灯的状态，测试按键的状态来间接计算人体反应速度。正常情况下系统运行主程序一直处于空闲等待状态，知道测试者按下按键后，LED测试灯立即点亮。AT89S52单片机在LED测试灯亮的同时开始计算一个随机时间，在一段随机时间结束后，AT89S52单片机 把LED测试灯熄灭，并开始计时灯灭与测试者放开按键的时间差，此计时时间用于纪录被测试者的反应时间，并以毫秒为时间单位在4位数码管上显示。如果在LED测试灯灭之前提前放开测试按键，则显示9999作为出错信息。 关键词：单片机；反应速度；AT89S52 ；LED； 数码管 Abstract This article is based on single chip microcomputer human reaction speed tests described, through the single chip microcomputer test response speed. AT89S52 MCU as the core in the design of the human body reaction velocity tester, mainly by controlling the state of the test lamp, in the state of the test button to indirect calculation of human body reaction speed. System normal operation of the main program has been idle waiting state, know the tester after press the button, the LED test lamp light up immediately. AT89S52 single chip microcomputer in LED to test the lights at the same time began to calculate a random time, at the end of a random time, AT89S52 single chip microcomputer test the LED lights, and start timing lights and testers release button lag, this timer is used to record the subjects reaction time, and in milliseconds as the unit of time in the four digital tube display. If the LED test before the lights went out early release test button, 9999 as the error message is displayed. Design USES AT89S52 single chip microcomputer, its to high performance low price advantage to become one of the world scope the most widely used microcontroller; Display part adopts LED digital tube display, this set of system in the case of does not affect the test performance, greatly save the design cost, is the high cost performance of a human reaction test. Compared with other tester has obvious price competitive a