手机射频校准错误代码表.docVIP

手机射频校准错误代码表（适用于展讯，MTK芯片） Lacation update Fail = 101;位置更新错误 MT Call Fail = 102;手机呼叫失败 Call Drop = 103;掉线 Average Burst Power Fail = 104;平均突发功率超出模板 Peak Burst Power Fail = 105;峰值突发功率超出模板 PVT Match Fail = 106; PVT超出模板 Timing Error Fail = 107;时序偏差超出模板 Phase Error Peak Fail = 108;峰值相位误差超出模板 Phase Error RMS Fail = 109;均值相位误差超出模板 Frequency Error Fail = 110;频率误差超出范围 Spectrum due to Modulation Fail = 111;调制频谱超出模板 Spectrum due to Switching Fail = 112;开关频谱超出模板 Rx Quality Fail = 113;接收灵敏度超出范围 Rx Level Fail = 114;接收电平超出范围 BER Fail = 115;误码率超出范围 BLER Fail = 116;误块率超出范围 METAAPP_GET_AVAILABLE_HANDLE_FAIL = 201;Meta可用到的操作失败 METAAPP_OPEN_UART_FAIL = 202;Meta打开Uart口失败 METAAPP_CLOSE_UART_FAIL = 203;Meta关闭Uart口失败 METAAPP_BOOT_FAIL = 204;Meta连通串口失败 METAAPP_BOOT_STOP_FAIL = 205;Meta终止连通串口失败 METAAPP_INIT_FAIL = 206;Meta初始化失败 METAAPP_WAIT_FOR_TARGET_READY_FAIL = 207;Meta等待被测件准备失败 METAAPP_COMM_SET_BAUD_RATE_FAIL = 208;Meta命令设置波特率失败 METAAPP_COMM_START_FAIL = 209；Meta命令开始失败 METAAPP_COMM_STOP_FAIL = 210；Meta命令终止失败 METAAPP_CONNECT_WITH_TARGET_FAIL = 211；Meta连接被测件失败 METAAPP_DISCONNECT_WITH_TARGET_FAIL = 212；Meta断开被测件失败 METAAPP_RF_SELECT_BAND_FAIL = 213；Meta选择射频频段失败 METAAPP_RF_SELECT_BAND_CNF_FAIL = 214 METAAPP_RF_AFC_MEASURE_FAIL = 215；Meta测量AFC失败 METAAPP_RF_AFC_MEASURE_CNF_FAIL = 216;Meta测量AFC配置失败 METAAPP_RF_AFC_SET_DAC_VALUE_FAIL = 217;Meta设置数模转换电压失败 METAAPP_RF_AFC_SET_DAC_VALUE_CNF_FAIL = 218；Meta设置数模转换电压配置失败 METAAPP_RF_CRYSTALAFC_SET_CAPID_FAIL = 219；Meta控制晶体设置CAPID失败 METAAPP_RF_PM_FAIL = 220；Meta控制电源管理失败 METAAPP_RF_NB_TX_FAIL = 221；Meta控制邻道发射失败 METAAPP_RF_NB_TX_CNF_FAIL = 222；Meta控制邻道发射配置失败 METAAPP_RF_SET_APC_LEVEL_DAC_FAIL = 223；Meta设置APC等级数模转换控制失败 METAAPP_RF_SET_APC_LEVEL_DAC_CNF_FAIL = 224；Meta设置APC等级数模转换配置失败 METAAPP_RF_STOP_FAIL = 225；Meta终止失败 METAAPP_RF_STOP_CNF_FAIL = 226；Meta终止配置失败 METAAPP_RF_BBTXAUTOCAL_FAIL = 227；Meta控制基带发射自动校准失败 METAAPP_RF_GETBBTXCFG2_FAIL = 228 METAAPP_RF_SETBBTXCFG2_FAIL = 229 METAAPP_RF_SETAFCSINEWAVEDETECT_FAIL = 230 METAAPP_RF_SET_MT6140CW2_TO_REG_FAIL = 231 M