神州天勤HA安装过程.docx

一、JBOSS服务器 1、停止redhat cluster（在两台机器上都操作） 先在cluster管理界面disable服务，然后停止rgmanager、cman服务 #/etc/init.d/rgmanager stop #/etc/init.d/cman stop #/etc/init.d/modclusterd stop #chkconfig rgmanager off #chkconfig cman off #chkconfig modclusterd off 注释掉/etc/rc.local里面的cman、rgmanager启动行。 #service cman start #sleep 5 #service rgmanager start 2、检查iptables和selinux都是禁用的 [root@server14 ~]# cat /etc/selinux/config # This file controls the state of SELinux on the system. # SELINUX= can take one of these three values: # enforcing - SELinux security policy is enforced. # permissive - SELinux prints warnings instead of enforcing. # disabled - SELinux is fully disabled. SELINUX=disabled # SELINUXTYPE= type of policy in use. Possible values are: # targeted - Only targeted network daemons are protected. # strict - Full SELinux protection. SELINUXTYPE=targeted [root@server14 ~]# iptables -L Chain INPUT (policy ACCEPT) target prot opt source destination Chain FORWARD (policy ACCEPT) target prot opt source destination Chain OUTPUT (policy ACCEPT) target prot opt source destination 3、修改/etc/hosts文件 [root@server15 ~]# cat /etc/hosts # Do not remove the following line, or various programs # that require network functionality will fail. 127.0.0.1 localhost.localdomain localhost #::1 localhost6.localdomain6 localhost6 192.168.10.14 server14.localdomain server14 192.168.10.15 server15.localdomain server15 10.10.5.14 node14 10.10.5.15 node15 4、安装skygeha软件 [root@server14 ~]#mkdir iso [root@server14 ~]#mount skygeha-6.0-x86_64-Fenghuo.iso iso –o loop [root@server14 ~]#cd iso [root@server14 iso]#./install_ha.sh 5、配置skygeha [root@server14 iso]# su - [root@server14 ~]# skygeha_admin ------------------------------------------------------------------------ SKYGE HA 6.0 Configuration Utility Tools ------------------------------------------------------------------