2012年湖北省二级建造师考试题及答案(国外英文资料).docVIP

2012年湖北省二级建造师考试题及答案(国外英文资料) In 2012 two construction division examination construction A single choice (a total of 20 points, 1 points for each question, options for each question, only 1 of the most to do) 1. ordinary reinforced concrete structure with the main varieties of steel is (). A. hot rolled steel Heat treatment of B. steel C. wire D. steel strand Answer [A] 2. in the reinforced concrete beams, the main effect of stirrups is (). A. bear due to bending tension B. bear due to bending stress C. shear D. bear due to concrete shrinkage and temperature stress Answer [C] 3. residential buildings, the ground eight floors, building height of 24.300m, the genus (residential). The lower house of A. B. multi-storey residential High-rise residential C. D. high-rise residential Answer [C] 4. the building height control area real layer, elevation of outdoor ground -0.300m, roof surface elevation is 18.00m, parapet vertex elevation is 19.100m, highlighting the roof of the refrigerator is the highest point between the top surface of the building, its elevation is 21.300m, the building height (m). A.18.300 B.19.100 C.19.400 D.21.600 Answer [D] The 5. construction steel tensile test indicators in the (not included). The yield strength of A. The fatigue strength of B. The tensile strength of C. D. elongation Answer [B] 6. masonry structure wall and column height to thickness ratio calculation, in order to ensure the wall, meet the requirements (column). The bearing capacity of A. compression Shear bearing capacity of B. Local compression bearing capacity of C. The stability of D. Answer [D] 7. determined by the compressive strength of concrete standard, the curing time is (). A.7 day B.14 day C.21 day D.28 day Answer [D] The 8. main functions of engineering measurement level is (). Gao Cheng A. of the point to be measured directly B. measurement of water the angle between two directions C. height difference between the two measurements D. direct measurement of the vertical an