mplayer(国外英文资料).doc

mplayer(国外英文资料) The 2nd house -- Hey, I am here! Myamo cublog.cn homepage |, | album |, | Mplayer Settings are commonly used in the Preferences in the Settings, open a way: in the window of the mplayer (either Video playback controls window or window) point on the right, choose Preferences, can be opened (certainly must pay attention to the warning point OK before into). 1, vo (Video Output) This is the most important Settings, if set wrong, even if you already according to each package installed, set the guide cannot normal watch, the most common mistake is: Error opening/the initializing the selected video_out (vo) device. Set this option in the window of the mplayer (either Video playback controls window or window) points on the right, choose Preferences, after opening (pay attention to the tip point of course OK to into) select the Video TAB above, choose one in the driver, such as one of the most common is xv. If it doesnt work for you, try it yourself and other drivers. Note: once again, you need to restart mplayer to get results. 2, ao (Audio Output) This is the drive to set the sound, and if the Settings are not correct, the sound card or image will appear in the WMV, RMVB, etc. The basic operation is the same, but the open TAB is Audio. For example, when I set it to alsa, I had the problem, and then I changed it to SDL. (only for dapper in the source version, not including 1.0 rc1, just like with with alsa in 1.0 rc1, besides, Im just on my machine) in the same way, was also set according to their own situation. The sound is not in sync with the image I didnt have this problem, but I saw some posts saying that Enable frame Dropping (allowing frame Dropping) to be checked for the Video TAB. 4, image rollovers There is also a problem with the solution: remove the flip image upside down from the Video TAB. If your Settings dont already have an image flip, check it again. 5, play DVD or VCD In 6.06, the DVD position doesnt seem to be/dev/DVD, at least my machin