BASF地下管道试压方案.doc

目录 1．General工程概况 1 2 编制依据References 1 3 管道压力试验一般要求General For Pipe Pressure Test 2 4 压力试验规定Pressure test requirements 2 5试验准备Test preparations 4 6 试验步骤Test procedures 5 7 压力试验完成后 After pressure test 6 8.质量保证措施Quality guarantee measurement 7 9 人力资源计划Manpower Arrangment 7 10 Utilization of Equipments机具材料使用计划 8 11. 安全、健康、环保（HSE） 9 12. 安全分析safety analysis 10  地下管道压力试验方案 Method Statement for 1．General工程概况 本工程位于。 业主方为巴斯夫公司(简称B)，管理公司综合专业工程由中国化学工程（以下简称“CC”）承建。The?project?is?Lemongrass Project which is located in Gebeng industrial Park of Kuantan Malaysia. The Owner is the BASF-Petronas Chemicals (BPC) Complex. Management company is the FLUOR. Multi-discipline work (Area C400) is contracted and constructed by China Chemical Engineering Malaysia Company. (hereinafter referred to as CCEM) 工程简介 本工程地下管道较小，共计管线可将其划分为两个试压包；因其中条管线属于预埋在混凝土基础内，所以必须在混凝土基础完工之前试压，预埋，一个试压包需分两次试压。管道试压均按设计要求采用洁净水作为试验介质。编制依据References 施工设计图纸及技术要求Construction design drawing and technical requirements; 2本项目的施工合同 Project Construction Contract 2.国际通用标准：International Standards3本项目管道工程相关标准和技术文件； 5我公司企业标准 Company Standards 3.1管道安装完毕，无损检验合格后，按划分好的试压包进行管线检查，合格后按设计及施工验收规范的规定对管道系统进行强度、严密性试验，以检查管道系统及各连接部位的工程质量。After process piping installation and NDE qualification, line check should be carried out based on pressure test packages, then strength and leak test for piping system should be carried out to inspect the project quality of piping system and connection location after line check qualification based on engineer and construction acceptance specification. 3.2 本工程管道液压试验主要以洁净水为试验介质。当管道的设计压力小于或等于0.6MPa 且无法采用液体进行试验时，也可采用压缩空气或氮气作为试验介质，但应采取有效的安全措施。The engineering makes clean water mainly as the test medium for pipe hydrostatic test. If the design pressure of the pipe is less than or equal to 0.6MPa and unable to use the liquid for testing, we make compressed air or nitrogen as the test medium, but we should take effective security measures. 3.3 当现场条件不允许使用液体或气体进行压力试验时，经建设单位同意，可采用射线照相或超声波检验。If field conditions do not a