ug超详细的钣金设计教程.pptVIP

* Morning Session Welcome Introductions Gateway Presentation Gateway Exercises Modeling Presentation Modeling Exercises Q A LUNCH Afternoon Session Drafting Presentation Drafting Exercises Assemblies Presentation Assemblies Exercises Smart Models Presentation Smart Models Exercises. Q A Close * Load Standards The default file is named ugsmd_def.std and is located by the environment variable UGII_UGSMD_STDS_LIBRARY. * Load Standards The default file is named ugsmd_def.std and is located by the environment variable UGII_UGSMD_STDS_LIBRARY. 不适用于无Clearance Points的情况 Sheet Metal Bracket(钣金支架) Sheet Metal Bracket(钣金支架) Exercise Activity 12-1 Bracket Creation P.348 ~ P.358 Lesson 13 Multibend Bracket(多次折弯钣金支架) 通过参考其它几何体来生成一个复杂的钣金支架，它是一个全相关的特征。 Lesson 14 Sheet Metal Routed Relief It is not a feature, but a utility that constructs a routed relief outline curve and a Sheet Metal Cutout feature. While this utility is designed to work with Flanges or General Flanges, it can also be applied to any planar geometry. This utility rounds the far ends of two adjacent flanges and adds the relief to the common corner between them. Lesson 15 Sheet Metal Corner (钣金拐角) 在相邻两个Flanges之间生成钣金拐角 四种类型： Butt Joint ---- 对接接头 Machinery Simple Miter ---- 简单斜角缝 Full Miter ---- 封闭斜角缝 Butt Joint MachineryV18 Simple Miter V18 Full Miter V18 Sheet Metal Corner (钣金拐角) Sheet Metal Corner (钣金拐角) Overlap Sheet Metal Corner (钣金拐角) Gap Lesson 16 Sheet Metal Strain The Sheet Metal Strain utility is used to map a collection of points, curves and/or edges from a collection of region faces/sheets to an alternate collection of mapping faces/sheets Lesson 17 Part in Process(钣金零件加工过程) Application ? Sheet Metal ? Design Tools ? Part in Process 只能对Sheet metal feature进行操作 Process：A Process is a collection of Groups of Features Group：A Group is a collection of features Feature：A Feature is a defined state of a sheet metal feature in the model Part in Process(钣金零件加工过程) Process Group Lesson 18 Fl