CATIA官方培训资料 CATIA汽车管路.pptVIP

Copyright DASSAULT SYSTEMES 2002 Tubing Design管路设计 Course Presentation课程介绍 Objectives of the course目标 In this course you will learn how the CATIA Tubing Design product is used to quickly and efficiently create an intelligent tubing layout. 智能化管路设计 Targeted audience Experienced CATIA V5 users 目标学员 有使用经验的CATIA用户 Prerequisites CATIA V5 Fundamentals 予要求：CATIA V5基础 Table of Contents目录 Introduction to Tubing Design Fundamentals p.4 Accessing the workbench模块介绍 p.5 User Interface: Tubing Design Icons界面介绍 p.6 Creating Line ID’s生成管线ID码 p.9 Routing a Run 生成管线 p.10 Modifying a Run修改管线 p.14 Implementing Turn Rules管路拐弯 p.19 Placing Parts on a Run 管路定义功能 p.22 Generating Reports 生成管路拐点坐标 p.24 Accessing the workbench进入模块 To access the Tubing Design Workbench …进入模块 User Interface: Tubing Design Icons (1/2) User Interface: Tubing Design Icons (2/2) Routing a Run (1/4)生成管路 Routing a Run (2/4)生成管路 Select the Line ID选择管线ID码 Depending on what Line ID is choosen, CATIA lets you select a predefined Turn Radius. In this case is just one Turn Radius for the 3/8in diameter defined, which means that you won′t get a selection panel.根据选择的管线ID码，可以选择拐弯半径 Routing a Run (3/4)生成管路 Create the Run生成管路 Make sure that the Grid Step is set to 0.5 in. 确认步长为0.5in Routing a Run (4/4)生成管路 Create a Run from Point-To-Point点到点方式生成管路 Click the the next two connectors. The Run will be created.点击两个支座，生成管路 Modifying a Run (1/5)修改管路 Modify the Run修改管路 A new Run shall be created and afterwards being modified.先生成后修改 Therefore you create a new Run using the orthogonal mode as shown in the picture.使用对角线方式生成管路 After that you will modify the Run.然后修改 Modifying a Run (2/5)修改管路 Modifying a Run (3/5)修改管路 Modifying a Run (4/5)修改管路 Modifying a Run (5/5)修改管路 Implementing Turn Rules (1/3)拐弯 Implementing Turning Rules (2/3)拐弯 Implementing Turning Rules (3/3)拐弯 Placing Parts on a Run (1/2)插入接头 Placing Parts on a Run (2/2)插入接头 Generating Reports (1/2)生成弯管文件 Generating Reports (2/2) * *