冲浪者海外版V5说明书.doc

PAGE  PAGE 19 EXCLUSIVELY AT VERSION 5 1400MM SKY SURFER ASSEMBLY AND OPERATION INSTRUCTIONS MANUAL Thank you for purchasing the new 1400MM Sky Surfer from BlitzRcWorks. Assembly for this aircraft is kept at a minimum. This Sky Surfer is powered by a brushless outrunner motor paired with a factory calibrated electronic speed controller, ailerons, elevator and rudder control surfaces are controlled by servos; all of which are factory installed on the Ready-to-Fly version. All that is left is to charge the lithium polymer battery following the safety precautions. Please be sure to read the entire manual carefully prior to assembling/operating the Sky Surfer. The illustrations on the manual display the new 1400MM Sky Surfer Ready-to-Fly version with factory applied decals. General Notice Always dry fit the parts and test the electronics prior to any gluing and/or assembly. Suitable Adhesives Foam safe epoxy is recommended and available from most reputable model retail shops. Please follow the recommended curing time suggested by the glue manufacture to allow the glue to fully cure (harden) to the point of which the joints can be placed under stress. It is recommended to dry fit the aircraft prior to gluing thus having a general idea of how the unit comes together which may decrease the chances of mistakes occurring. Package Contents Fuselage with factory installed motor, electronic speed controller and servos Clear canopy and cockpit Main wing panels with aileron servos Tail wing panels: Vertical stabilizer and Horizontal stabilizer Before assembling the model Please check the contents of your kit before you start working on it. You will find Fig. 1 + 2 and the Parts List helpful here. Part No.No. off Description Material Dimensions 11L.H. fuselage shellAbb.121R.H. fuselage shellAbb.131Cockpit with pilotAbb.141L.H. main wing panelAbb.151R.H. main wing panelAbb.161Horizontal StabilizerAbb.171Vertical StabilizerAbb.181D