冷却水路设计方案moldflow report(CB-101001).ppt

冷却水路设计方案moldflow report(CB-101001).ppt

  1. 1、本文档共31页,可阅读全部内容。
  2. 2、有哪些信誉好的足球投注网站(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
  3. 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载
  4. 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
冷却水路设计方案moldflow report(CB-101001)

Part, Tool, Setup wall thickness and mesh statistics Simulation results list Fill time (contour) Pressure at V/P switchover Pressure at the end of fill Flow Front Temp. Maximum Shear rate Shear Stress at wall System Pressure Clamp Force Air Traps Weld Lines Volumetric shrinkage at ejection Sink index Circuit Layout Circuit heat removal efficiency Circuit flow rate and temperature Temperature part at the end of cooling Distortion of all effects Deflection (all deflection cause) Conclusions and suggestions FilIing Fill time Pressure at V/P switchover Pressure at the end of fill Flow Front Temp Volumetric shrinkage at ejection Circuit Layout Circuit heat removal efficiency Circuit flow rate and temperature Temperature part Distortion of all effects Distortion, all effects at Y Component Conclusions and suggestions * * * LIN KE SONG Composer 2010-10-13 Date Moldflow 6.1 Moldflow REV Part number handle bezel Part name CB-101001 Project numbered Appearance Requirements Deflection Requirements Nominal Wall Thickness Injection machine Tonnage Part Volume Part Details and Tool Description Packing Pressure Project Area Velocity/Pressure Transfer (% volume) Fill Time Mold Temperature Melt Temperature Material Process Setup Analysis Results 275.8 ℃ Minimum Melt Front Temperature 278.1 ℃ Maximum Melt Front Temperature 1203.6 T Clamp tonnage during filling/packing maximum clamp force 157.9 MPa Maximum injection pressure 217.0 cm3/s Maximum flow rate, beams Aesthetical part 2.50 mm 625.91 cm^3 PA213G33 275 ℃ 82 ℃ 3.39 s 98.04% 4927.81 cm2 One mold with 1+1 cavity. Mesh statistics Propose to decrease material for more than 4mm thickness locations of part . Plot PVT data Plot Viscosity General: Recommended Processing: Plastic Material Information Sprue Runner Gate Hot

文档评论(0)

shuwkb + 关注
实名认证
内容提供者

该用户很懒,什么也没介绍

1亿VIP精品文档

相关文档