吊车专业文档SystemReset-Mipeg2000Recording.pdf

RESET OF THE MIPEG SYSTEM Note: All calibration data and settings will be lost. Make sure to write down all calibration data and settings before doing the reset, so the data can be re-entered to the system after completion of this procedure. Click connect Enter code for level 4 Click System Page Click Set Cr.Id.Eeprom Wait until Ok ! is displayed on the Status line Verify that Crane Ident. No: is identical to Crane Id.No.Eepr: (324 both) Click Reset Prom Param. Click OK to reset system Wait until Ok ! is displayed on the Status line Click Set RTC Wait until Ok ! is displayed Verify that the Real Time Clocks (Date Year and Time) for Mipeg clock and PTU clock are near equal (+/- some seconds) Click System Page again Click Reset All Enter Usage Hours: (Number found in the header of the latest downloaded COR data) Click OK Enter Number of lifts: (Number found in the header of the latest downloaded COR data) Click OK Enter Number of Over lifts: (Number found in the header of the latest downloaded COR data) Click OK Enter Number of Moment Peaks: (Number found in the header of the latest downloaded COR data) Click OK Wait until Ok ! is displayed on the Status line. Click Disconnect. When system comes up in online mode verify that no error messages are displayed on the Mipeg 2000 Display. The Reset of the system should now be completed.