DB51100T 122-2013 社区养老服务管理规范.doc

DB51 四川省（区域性）地方标准 DB510100/T 122—2013 社区养老服务管理规范 （报批稿） XXXX - XX - XX发布 XXXX - XX - XX实施 成都市质量技术监督局发布 目次 前言 II 1　范围 1 2　规范性引用文件 1 3　术语和定义 1 4　社区养老服务基础设施 2 5　社区养老服务基本设备 2 6　服务内容及标准 3 7　服务管理及监督 6 前言 本标准按照GB/T 1.1-2009给出的规则起草。 本标准由成都市老龄工作委员会办公室提出。 本标准主要起草单位：成都市老龄工作委员会办公室。 本标准主要起草人：李康宁、高学伦、高剩勇、朱庆海、刘英、陈少雯、侯丹、廖华。 社区养老服务管理规范 范围 本标准规定了社区养老服务管理规范的术语和定义、社区养老服务基础设施和基本设备、服务内容及标准、服务管理及监督。 本标准适用于市术语和定义与老人15分钟_________________________________ DB510100/T 122—2013 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance wi