委托检验理规程.doc

委托检验管理规程 1.目的：建立委托检验管理规程，规范委托检验的管理。 2.范围：物料或产品的委托检验委托检验相关人员职责负责提出委托检验申请，填写委托检验申请单需检验物料或产品的检验项目、检验标准及要求的确定和送检；负责委托合同等记录归档和资料整理工作。按照委托检验结果完善检验记录，判定检验结果并进行记录归档  REC-ZL001R00 委托检验申请单 名称： 委托理由： 申请部门 申请人 申请日期 年 月 日 质量管理部审核意见： 日期：审核意见： 签名： 日期： 年 月 日 SMP-WT002 委托检验管理规程 版本号： the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the