IAR生成HEX文件说明.pdfVIP

Flash Programmer 5 Command Line Interface 5.1 Options To get all available options in the command line interface, run the SmartRF04ProgConsole.exe in a command window or in the IAR workbench without any parameters/arguments. A list of all available options will then be printed out. These options are the same as the ones available in the GU I version of the Flash programmer, please refer to chapter 4 for a description of these. 5.2 Plug-in to IAR Workbench The command line interface can be integrated in the IAR Workbench. To setup IAR with this feature follow the instructions below. 5.2.1 Setup Start IAR Workbench and choose “Configure Tools…”, from the Tools menu, Figure 7. Figure 7: Tools Menu Press “New”, and add the information present in Table 2, see Figure 8. Field Value Menu FlashProgram Text: Command: C:\Program Files\Chipcon\FlashProg\ 1 SmartRF04ProgConsole.exe Argument: S() EPV F=$TARGET_PATH$ K(0) Table 2: Flash Programmer Setup 1 Insert the complete path to the Command Line Flash Programmer SWRU069A Page 10 of 13 Flash Programmer Figure 8: Configure Tools 5.2.2 Use After setup, a new target is placed on the Tools menu. Figure 9: Using Flash Programmer from IAR Workbench Setup your project to generate hex file as primary output (Figure 11), compile and link, and choose “Flash Program” from the Tools menu. A command line window will be displayed, Figure 10. After