6502举动(国外英文资料).doc

6502动作(国外英文资料) 6502 relay sequence 1, according to the start button, the beginning of the end of AJ and increase in autism. Functions: (1) the start button indicates the flash of the lamp; (2) the excitation circuit of the corresponding FJ is connected; the route indication lamp is lighted; the corresponding direction power supply is sent; (3) send KZ or KF to the picking network. 2, according to the terminal button, AJ terminal and increase in autism. Role: (1) the terminal button flash; (2) to connect the FJ self closing circuit; (3) send KZ or KF to the branch network. 3. Turn on the 1~6 line. If the route is / reverse switch, the first switch on the 1 and 2 line, the switch 1FCJ and 2FCJ = and if the route has autism; reverse switch position, the first 3, the 4 line on the 1FCJ and 2FCJ increase turnout and autism (if there is route; / and switch counter, 1, 2, 4 line and 3 line connected at the same time) selected double acting reverse switch position is 5, 6 lines: first is the leftmost JXJ network up and then choose the double action switch closed, positioning the order from left to right, single action switch reverse and positioning, and the middle point of the JXJ signal, the network makes the right of JXJ = JXJ = SJZ and autism (switched on, flash button on the left side of the JXJ route; first up, disconnect AJ, J = A then right down, when the FJ down to JXJ (slow release): after the flash disappeared). With JXJ = 4, and the direction of the power supply before the end of the LKJ and FKJ increase and increase autism (train route only LKJ, LKJ absorption). 5, DCJ = FCJ = connected or switch switch control circuit operates outdoor turnout, turnout in place after the communication switch (DCJ and FCJ after suction self closing, until SJ falls down). Self closing circuit 6, terminal JXJ = AJ respectively is disconnected, the AJ down to FJ (slow release) down to JXJ down, the terminal button flash disappear, route setting lamp lights, the beginning of the e