ug模架变量表达式(国外英文资料).doc

ug模架变量表达式(国外英文资料) Variable expression specification AP_h A board thickness AP_off=fix_open A plate deviation = die off BCP_h B board thickness BP_off=S_off+supp_s*S_h B plate deviation = push plate deviation + push plate push plate thickness CP_h C board height CP_off=U_off+supp_u*U_h C plate deviation = pallet deviation + with pallet * pallet thickness CS_d C plate screw diameter C_w C board width Cl_off_x=- (mold_w/2) +C_w/2 on the left side of the C board X to deviate from the half width = + half width C template Cr_off_x=mold_w/2-C_w/2 right C plate X to deviation = half template width - half C plate width EF_w ejector plate width The side plate thickness EJA_h EJA_off=EJB_off-EJA_h-4*ETYP E from the end of the needle plate side plate = shift side plate thickness -4*ETYPE EJB_h bottom plate thickness EJB_off=BCP_off-EJB_h-EJB_open bottom pin deviation = bottom deviation - bottom pin thickness - bottom pin blank (PAD stud height) EJB_open=0 bottom board is empty (nail height) ES_d face and bottom pin fixing screw diameter ETYPE=0 thimble fixed form: =0 countersunk fixed; =1 surface, bottom needle plate fixed from the air GP_d guide post diameter GTYPE=1 guide post position: =1 on the A board; =0 on the B board H straight mold roof width I side die roof width Mold_type=I die support type = die holder PS_d fixed die and dynamic die screw diameter =M1 RP_d return pin (reset lever) diameter Thickness of R_h nozzle plate (projectile plate) R_height=supp_r*R_h projectile plate height = with or without projectile board thickness The R_off=AP_off+AP_h plate deviates from the =A plate and deviates from the +A plate thickness SG=0 die frame form: SG=0 is big water mouth, SG=1 is small water nozzle frame SPN_L=floor (ok_spn:: L) pull rod length SPN_TYPE=0 pull rod position form: =0 pull rod position outside; =1 pull rod position SPN_d pull rod diameter =20 S_h pushing plate thickness S_height=if (supp_s, =0) (supp_s*S_h) else (S_h) plate height = = (without push plate) (wit