XX公司危险废物管理计划.doc

2013年危险废物管理计划 、 、 编制单位: 哈巴河华泰黄金有限责任公司（盖章） 编制日期 2013年3月22日 XXXX公司 2013年度危险废物管理计划 为了规范公司危险废物管理，确保危险废物无害化处置，防止环境污染，提高危险废物管理水平，特制订2013年度危险废物管理计划。 一．公司基本信息 企业名称 XXXX公司 法人代表 XXX 详细地址 邮编 经纬度 环评批复产品名称及规模 金矿开采，开采规模880t/d 试/投产日期 2004年5月 企业负责人 联系电话（手机） 环保联系人 联系电话（手机） 二．生产情况 2.1本年度生产计划 本年度生产主要原料 本年度生产计划 产品名称 预计产量（吨） 产品名称 预计产量（吨） 金矿石 300000 黄金 0.7 氰化钠 250 石灰 1300 2.2生产工艺情况 产生危险废物的工序简要说明 全泥氰化炭浆吸附提金在浸出工段使用氰化钠，产生废氰化钠桶，在破碎、磨矿等过程，机器设备用机油，产生废机油。对矿石和尾矿化验时产生废酸 3．本年度危险废物产生情况预测 危险废物产生量预测 废物名称 危废编号（HW） the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of g