东莞技能晋升培训补贴项目及标准目录.doc

附件 技能晋升培训补贴项目及标准目录 资格证书资格代码补贴金额 资格名称A （）A1（初级）800元 A2（中级）1500元 A3（高级）2000元 B （国家职业资格证书、计算机信息高新技术证书、专项职业能力证书）B1 （专项职业能力） B1-1 200元 B1-2 400元 B1-3 800元 B1-4 1600元 Ｂ2 B2-1（初、中级） 600元 B2-2 （高级） 1000元 B2-3 （技师、高级技师） 1200元 ＢB3-1（初、中级） 1200元 B3-2 （高级） 1600元 B3-3 （技师、高级技师） 2000元 Ｂ B4-1 （初、中级） 1600元 B4-2 （高级）2200元 B4-3 （技师、高级技师）2500元 Ｂ B5-1 （初、中级） 2200元 B5-2 （高级） 2800元 B5-3 （技师、高级技师） 3000元 Ｂ B6-1 （初、中级） 2800元 B6-2 （高级） 3300元 B6-3 （技师、高级技师） 3500元 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with