该板外观结构图如下 - gbeshopcom.doc

User Guide for 3 axis TB6560 driver board Settings of MACH3 *Important Note*: Please strictly follow the setting photos for configuration in Mach3！ Fig.1 Open MACH3 software, select mach3MILL, and then click OK. Please refer to Fig.1 Fig.2 The interface of MACH3 is displayed as Fig.2. The frequently-used action buttons are listed on the interface. We can configure MACH software at first. 。 3 Click PORT PIN sub-menu of config menu. Please refer to Fig.3. Please refer to Fig.4 Fig.4 To set up the basic frequency within the above Circle 1. This parameter will affect the rotational speed of the motor. After the setup of basic frequency, select Circle 2 where Configuration Scripting will be defined, please refer to Fig.5. Fig.5 To modify the software settings according to the definition of Parallel Interface which is detailed in the above circle. Fig.6 Then select the output signals column, as shown in Fig.6, and set up the corresponding items per the setup described in the circle. Fig.7 After all have been set up, open the G CODE that needs to run, as shown in Fig.7 Fig.8 Fig.9 After G CODE has been opened, you may see the red button RESET flashing. Click RESET to stop the flashing and then press CYCLESTART at the location of Circle 2 *Simple solutions if the driver does not work properly: Please double check the software settings according to the Fig.5 and Fig.6 Please conform the parallel cable has been plugged tightly Please turn off the power supply before changing dip settings Please use stable high quality DC power supply for this driver Problems in Mach3 using, Please refer to the Mach 3 User Manual If problem persist, please feel free to contact us! Product Features: Toshiba TB6560AHQ chip - High power, maximum 3.5A drive current chipset ! 1-1/16 microstep setting - Higher accuracy and smoother operation than standard 1, 1/2 step! Adjustable 1.5A-3A drive current settings for each axis - 25%,50%,75%,100% of full current can be set for different stepper motor