第五章 卡乐1tool软件应用.ppt

Upload 2.Compile the project successfully, then click the button (pCO Manager) Unconnected pin If the pin was unconnected: Input pins will take the default value as the pin was connected to a constant Output pins will take a temporary variable automatically. Level: Field, Mask, Global The level is shown in the Key Function Editor The level is the same forthe Key Function Editor and Property Block Execution Order Note : You can’t place two blocks with the same number in the same page. You can use Jump_Start and Jump_End blocks to skipsome blocks during the execution. pLAN units Max 32 units (only terminals can have address=32) Any combination is allowed pCO3/2 pCO1 pCOXS pCOC LCD4x20 PGD0/1 PGD2/3 ARIA/PAD FCM EVD – Electronic Expansion Valve Driver Supernode The BMS and the pLAN network are independent networks Features of the pLAN network: Each controller can show its masks into up to 3 terminals(Private or Shared)+builtin Send variables among controllers (max.2048 outgoing links for each controller) pLAN devices Any type of pCO, TXT/PGD terminals, Aria/pAD, EVD, FCM Any combination is allowed Max 32 units (only terminals can have address=32) NetworkEditor Insert in one or more NetworkPage the controllers, terminals, parametric pLAN Define address and project define links using pLAN Table The variables used in a link must have the “pLAN” flag checked Setup pLAN pLAN network (1/2) Compile and Upload application files into pCO Set pLAN address to pLAN devices Connect pLAN devices (Wiring) Configure terminal Terminal configuration System mask (press UP+DOWN+ENTER for 5sec) System variables PLAN_TERM_CONF* NetworkEditor (Terminal property, Setup button) (?Default configuration) The value of the variable is sent everytime it changes and as soon as the communication startsNOTE: variable form X to T are not sent at startup pLAN alarms management pLAN system variables (most important) PLAN_ADDRESS: pCO address PLAN_INFO: bit15=pCO is communicating, bit14