以下为USB测试标准,参考标准为USBSpecificationRevision.docVIP

以下為USB測試標准，參考標准為USB Specification Revision 2.0 USB　Electrical,Mechanical,and Environmental Compliance Standards Test Descriptio Performance Requirement Visual and Dimensional Inspection Must meet or exceed the requirements specified by the most current version of Chapter 6 of the USB Specification. Insulation Resistance 絕緣電阻 大于等于1，000Ω Dielectric Withstanding Voltage 耐電壓 The dielectric must withstand 500V AC for one minute at sea level. 500　V　AC，一分鐘 Low Level Contact Resistance 低電平接觸電阻 30 mΩ maximum when measured at 20mV maximum open circuit at 100mA.Mated test contacts must be in a connector housing. 在開路最大電流為100 mA電壓為20mV情況下最大為30mΩ Contact Current Rating 溫升 1.5A at 250V AC minimum when measured at an ambient temperature of 25℃.with power applied to the contacts ,the △T must not exceed +30℃at any point in the USB connector under test. 相對溫度為25℃，250VAC，最小為1.5A。接通電壓，測試中端子任一點的溫度不超過＋30℃。 Contact Capacitance 接觸電容 2 pF maximum unmated per contact. 最大為2pF Insertion Force 插入力 35 N maximum at a maximum rate of 12.5㎜ per minute 在插入速度不超過每分鐘12.5㎜時不超過35N Extraction Force 撥出力 10 N minimum at a maximum rate of 12.5㎜ per minute 在拔出速度不超過每分鐘12.5㎜時不超過10N Durability 耐用性 1,500 insertion/extraction cycles at a maximum rate of 200 cycles per hour. 在速度不超過每小時200個循環下經受1，500次插入與撥出。 Cable Pull-Out 電纜拉出 After the application of a steady state axial load of 40 N for one minute 固定后施加40N的軸向力,一分鐘。 Test Descriptio Performance Requirement Physical Shock 物理沖擊 No discontinuities of 1μs,or longer duration when mated USB connectors are subjected to 11ms duration 30 Gs half-sine shock pulses.Three shocks in each direction applied along three mutually perpendicular planes for a total of 18 shocks. 匹配USB端子，中斷不得大于或等于1μs,30Gs的半波脈沖承受11ms.從三個正交的方向施加沖擊，總沖擊數為18次 Random vibration 任意振動 No discontinuities of 1μs,or longer duration when mated USB connectors are subjected to 5.35Gs　RMS.15minutes in each of three mutually perpendicular planes 匹配USB端子，中斷不得大于或等于1μs,承受5.35Gs　RMS.朝各個正交的方向各振動15分鐘。 T