奥的斯3200故障代码（Otis 3200 failure code）.doc

奥的斯3200故障代码（Otis 3200 failure code） Otis TOEC 2000.300 VF. 3200 OCSS: key sequence M-1-2-2-1: event record M-1-2-2-2: operation mode record LMCSS: key sequence M-2-2-2: event record Clear fault method: to clear a single failure, press SHIFT + ENTER to clear the fault in the display when the ST is displayed If you know all the fault records, press SHIFT + 5 and then follow the instructions above to confirm OVF30: key sequence M-4-2-1: view the current failure M-4-2-2: view storage failure M-4-2-3: clear fault record 3100 OTIS2000 LCBII: key sequence M-1-2-1: view the event record OVF20: key sequence M-2-2-1: view all event records that have been switched on for the last time M-2-2-2: check all previous uncleared failure records for the last connection Troubleshooting method: key SHIFT + 5, then follow the above reminder to clear Otis 3200 failure code Fault source system execution The code server displays 2000 STM software reset electronic board software running error, causing CPU reset 2001 STM power on reset to reset, or press reset button 2002 STM power fail 5V power supply voltage is less than 2.5v. During system outage, the system stops In 2005 STM not available certain abnormal conditions were detected by MCSS, and other fault records should be checked. In addition, this record was also recorded in emergency or maintenance conditions Source location reference The code server displays 22,100 PSR Big pos slip is too large for a wire rope to move in the same direction as the elevator 2101 PSR Big neg slip and the steel wire rope slip too large for the opposite direction of the elevator The position of PSR Pos mes FLT PVT is located in the flat zone, but DZ has no input and should check the photoelectric 2103 PSR Inv FLOOR COUNT invalid FLOOR counting, COUNT and the actual shaft FLOOR FLOOR number is inconsistent, or exceed the highest or lowest floors. Generally occur in capsules position is moved, when the power is cut off again after sending the fault 2104 PSR