海蜘蛛叠加带宽（Sea spider overlay bandwidth）.doc

海蜘蛛叠加带宽（Sea spider overlay bandwidth） This article is made up of taboo stones DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. CD-ROM installation sea spider routing graphics tutorial Source: Internet cafes finishing add to Baidu to QQ bookmarks 2009-07-09 18:30:48 First put the installation disk into the drive for the computer to be installed, and enter the computer BIOS settings, set the CDROM as the first boot device, that is, starting from the CD-ROM drive. After you start, youll see the following startup menu: The first item: CD-ROM normal installation mode (Chinese interface) [default] second: CD-ROM rescue installation mode (English interface) Third: U disc normal installation mode (Chinese interface) Fourth: U (English rescue disk installation mode interface) Use the up and down arrow to select the appropriate entry, the selected item will be highlighted, press the [ENTER] key to continue, and if not selected, the first item will automatically start in 10 seconds, that is, enter the normal setup mode. If the normal mode starts to fail, the installer automatically goes to the rescue mode. When the system starts, the main interface is installed, as follows: English interface is as follows: Install the sea spider routing system by [ENTER], the installer will automatically detect the hardware, and then initialize the hard disk, before initialization will ask you to confirm whether to continue. English interface is as follows: If you are sure you want to install, press [ENTER] to continue, or enter N; terminate the installation. The installation of the routing system only takes about 1 minutes, and every step has detailed information: If the installation is successful, you will be prompted later to modify the IP address of the LAN interface: If you dont want to change the default IP address and subnet mask, press [ENTER]. Next, you will see the successful prompt