十年CAD制图经验（Ten years of CAD graphics experience）.doc

十年CAD制图经验（Ten years of CAD graphics experience） Ten years of experience sharing CAD (not re - completion of the full version of the novice must see) Ten years of CAD experience sharing {work want good thing, must first benefit its device}, I think beginners must see Over many CAD materials, if compared to those CAD learning materials, it can master this software in a certain extent, if the design institute or firm, also can start drawing reluctantly. But I dont think its enough. Theres still a long way to go from books to practice. I graduated from Tongji University in the early years, and now I have been a registered architect, looking at a lot of children in the company. Although these children can complete the drawing and the simple design work, but I feel from the real master and uses CAD, but also has many distances. As for the companys other specialties, it can be described as miserable. Therefore, I will continue to write about CAD a series of experience, will be published at the same time, in our journals I also published here, for you. AUTOCAD use experience serialization Three basic aspects of using At present, our companys design documents, especially drawings, are drawn with AUTOCAD software. However, there are still a lot of people on CAD are not very familiar with, or use is not handy, so the efficiency is not very high, it can be said, in our company, draw a drawing the same, fast and slow in time may be a difference of several times. At the same time, everyone draw out the drawings do not feel the same look, some drawings look clear, clear and beautiful, and some drawings not only the expression is not clear, too much points can be used to describe too horrible to look at. From the beginning of the project design, I will be more than ten years experience as a serial bit by bit, for our people, hope to be helpful to everyone, from one or two to draw, to develop good habits, improve the speed of drawing drawing. At the same time, I also hope that this