应用文件（Application file）.doc

应用文件（Application file） The necessary knowledge and rules, 2013 driving test clearance cheats 1, reverse storage Compared with the original electronic pile, remove the transfer, only inspects the vehicle in driving horizontal, divided into left and right sides are respectively vertical garage skills. The whole room is a convex shape, the examinee drove into the examination room after the beginning of the test, the convex raised above the garage in the vehicle should be the right direction, you should first put on the left side of the vehicle driving to a convex end of line, and then to the right rear reversing storage, in between can not stop. After storage, drive to the left ahead of the convex word, the right side of the end of the sideline, and then left to the back of the warehouse, to complete the exam. Difficulties: the middle can not stop, completely negate the current examination of electronic pile, in situ killed the direction and identify the boom and the front of the glass mark. In addition, candidates need to relearn how to observe the sidelines from the rearview mirror. Tip: a little pause is allowed prior to the preparation of the warehouse. The candidate may take the opportunity to observe the garage line from the rearview mirror and determine the angle of the steering wheel when reversing the car. 2, ramp parking and start The old nine third Banpo starts, candidates need to drive to the slope from the center, the front wheel must stop position line. After passing inspection can not occur after the ramp start, slip. Any step wrong will lead to points or even failed. Difficulty: test car and coach car, not easy to appear after the master clutch slip. Tips: drive to the slope from the center by identify windshield signs and markings overlap, to decide what time parking (coach taught), and started pay attention to gently release the clutch, while small foot on the accelerator, to release the parking brake, prevent slip. 3 side parking There is no differen