斑马打印机的传感器（Zebra printer sensor）.docVIP

斑马打印机的传感器（Zebra printer sensor） Zebra printer sensor The printers sensor has Paper feed sensor, paper out sensor, The inkjet printer has a car position sensor, and the upper part of the cleaning unit is provided with a cart back position Sensor, In addition, there are laser scanners. These are relatively simple. Something more about the zebra printer. I hope you can use it Zebra label printers use the whole process: 1. ribbon and label installation According to the drawing direction, the dotted line is the ribbon installation path, are for the label path. Rewind ribbon easily peeled off after the waste, with waste label smooth bottom roll in the scroll in the back into the front, and then the ribbon. When installing the label, adjust the paper holder according to the label width. The pressure head spring is uniform and can avoid the deviation of the printer label. The first time you use a printer, you need to carry out measuring paper. 2. panel control PAUSE key: pause and start printing FEED key: take a piece of paper CANCEL key: when the print data is transferred to the printer, but without printing, you can press PAUSE first, and then press CANCEL several times until the data light is closed. CALIBRATE: tag test. When you install the new specification label, you can print the parameters of the tag before you print it properly. Method: press the PAUSE key first, then press CALIBRATE to do the measuring paper. When the paper is checked, the label has an acceleration process, indicating that the paper is correct. Note: the test paper can rewind finished label, ribbon cannot rewind. 3. equipment debugging Customers can choose according to their own requirements to print SETUP into the set temperature value Tear - Darkness off - Print mode ----------PEEL label from OFF (tearing way) - --------NON-CONTINOUS Media type Print Method (discontinuous paper) --------THERMAL TRANS (thermal transfer) Print Width - List Formats - print width format list List Setup - set Media a