扩孔、调齿、FET的方法与注意事项（Methods of reaming and adjusting teeth and FET and matters needing attention）.doc

扩孔、调齿、FET的方法与注意事项（Methods of reaming and adjusting teeth and FET and matters needing attention） Methods of reaming and adjusting teeth and FET and matters needing attention In my opinion, is nothing more than the basic AEG modified reaming, and the installation of FET gear adjusting circuit, perhaps these transformation does not make the power and speed changed obviously, but improve the mechanical and electrical work efficiency and durability of the key. At the end of 08 to save ones own version of the M4 (90%81 parts) the experience and methods, modified release up is to make a contribution for the forum, but also for future plans in a similar way modification enthusiasts who do a demonstration. Reaming: Personally believe that under the premise of M140 power, 8mm bearings are the ideal cup, lubrication is better than steel cup, it will not grind the shaft. Although the 8mm bearing cup with disabilities than ordinary steel cup, not much expensive, but because of the need to purchase additional reaming and reaming requires a high level of 8mm makes the most of game player bearing cup, in fact, is not prohibitive, expanding what is difficult, the most important experience, following the reaming of my experience made up for all to share. DSC02168.jpg (116.63, KB) 2009-1-25 13:52 Almost new 812 integer wave, wash the wave shell first, prepare for reaming. DSC02170.jpg (107.3, KB) 2009-1-25 13:52 8mm bearing cups cant be more expensive than steel cups. Remember, its best to buy a 2.5mm cup of thin thickness. Take the VS reamer as an example. This reaming tool has a relatively fast reaming speed, and it can expand a hole in 30 seconds after being skilled. DSC02173.jpg (112.21, KB) 2009-1-25 13:52 The first time reaming, pay attention to light and slow, must not be eager for quick success, the reaming process is irreversible, if the expansion of the bad, it is troublesome. The left hand holds the wave shell, the right hand slowly turns the reamer, gently a little bit of