DUALSHOCK3摇杆包括更换-iFixit.PDF

DualS ock 3 Analog Stick Covers Replacement DualShock 3 Analog Stick Covers Replacement Replace your PS3 controllers rubberized analog stick cover. Written By : Andrew Book olt © iFixit — CC BY-NC-SA www.iFixit .com Page 1 of 8 DualS ock 3 Analog Stick Covers Replacement INTRODUCTION Use t is guide to replace t e molded analog joystick covers on a DualS ock 3 controller. T e electronic joysticks are soldered to t e controller board. TOOLS: P illips #0 Screwdriver (1) Tweezers (1) © iFixit — CC BY-NC-SA www.iFixit .com Page 2 of 8 DualS ock 3 Analog Stick Covers Replacement Step — Rear Cover  Remove t e five 7.2 mm P illips screws securing t e rear cover to t e controller. Step 2  Pus t e center of t e rear cover (between t e two analog sticks) and slig tly lift t e lower edge of it away from t e rest of t e controller. © iFixit — CC BY-NC-SA www.iFixit .com Page 3 of 8 DualS ock 3 Analog Stick Covers Replacement Step 3  Pus t e rear cover slig tly toward t e top