动力齿轮齿条转向替代-iFixit.PDF

Power rackpinion steering Replacement Power rackpinion steering Replacement Replace your power steering rack pinion Written By : Brian Robinson © iFixit — CC BY NC SA www.iFixit .com Page 1 of 6 Power rackpinion steering Replacement INTRODUCTION Replace your power steering rack pinion © iFixit — CC BY NC SA www.iFixit .com Page 2 of 6 Power rackpinion steering Replacement Step 1 — Power rackpinion steering  From inside the vehicle on drivers side use a 11mm socket to remove the three nuts that secure the boot to the firewall  Using a 10mm sockst Remove the two pinch bolts form the shaft and remove shaft boot Step 2  raise and support the front of the vehicle  place the jack stands in the reinforced area j ust behind the engine cradle  Use a 19mm socket remove both front tires  remove the cotter pin and castle nuts from tie rod ends  remove tie rod ends from steering knuckle © iFixit — CC BY NC SA www.iFixit .com Page 3 of 6 Power rackpinion steering Replacement Step 3  remove the two Nuts and Bolts that secured flex pipe to the y pipe  From inside the engine compartment remove the three nuts that secure the strut to the strut Tower on both sides  place a floor jack with a short piece of 2 by 6 under the transmission pan  Raise Jack until it j ust starts to lift the transmission © iFixit — CC BY NC SA www.iFixit .com Page 4 of 6 Power rackpinion steering R