调整伊瓦涅斯SR405QM桁架杆 - iFixit.PDF

dj usting Ibanez SR405QM Truss Rod Adjusting Ibanez SR405QM Truss Rod High tension caused by the strings can cause the wood of the fret board to bow. This bowing can become so extreme it becomes difficult or impossible to play on due to the string height. Thus, in this guide we will learn to loosen or tighten truss rod. Written By : Chris Pittner INTRODUCTION The truss rod can be replaced with the strings on or off. Because the llen wrench is bulky , this guide will show how to adj ust the truss rod with the strings removed. Once the strings are removed, the fretboard will begin to slightly bend upwards or downwards. This will determine how much adj usting will need to be done on the truss rod. TOOLS Hex Key/ llen Wrench (1) Online Tuner (1) Phillips #1 Screwdriver (1) Flush Wire Cutters (1) © iFixit — CC BY-NC-S www.iFixit .com Page 1 of 11 dj usting Ibanez SR405QM Truss Rod Step 1 — Strings  Loosen all of the strings completely by turning each tuning peg counter clockwise. Continue until there is no tension in the strings Step 2  Remove each string by pulling it out of the string tree at the top and through the bridge at the bottom. © iFixit — CC BY-NC-S www.iFixit .com