工厂品质部质量术语.docx

AFR Annual Failure Rate 年度返修率ACC Acceptable 允收AQL Acceptable Quality Level 品质允收水准ASQ American Society for Quality 美国品质协会AVL Approved Vendor List 合格供应商清单APQP Advanced Product Quality Plan 产品质量先期策划BOM Bill Of Material 材料清单B/R Batch Run 量试C/R Corrective Action 矫正措施CA Customer Service Department 客户服务部CAR Corrective Action Request 矫正措施要求CCC China Compulsory Certificate 中国强制认证（安规）CE Communate Europpene（法语）欧盟CET Customer Experience Test 顾客体验测试CIP Continuous Improvement Program 持续改善项目CLCA Closed Loop Corrective Action 闭环纠正措施CPK Process Capability Index 工序能力指数CSA Canadian Standards Association 加拿大标准协会（安规）CQC China Quality Certification Center 中国质量认证中心CR Control Run 控制运行（特控量试）DFA Design For Assembly 设计的组装性DFM Design For Manufacturing 设计的制造性DFSS Design For Six Sigma 6标准差设计DOE Design Of Experiments 实验设计DPPM Defect Parts Per Million 百万分之不良率DPMO Defects Per Million Opportunities 百万分之不良机会DVT Design Verification Test 设计验证测试DAP Dead after Purchase 购买后损坏DOA Dead On Arrival 开箱损坏ECN Engineering Change Notice 工程变更通知ECR Engineering Change Requirment 工程变更需求ESD Electric Static Discharge 静电放电EVT Engineering Verification Test 工程验证测试EMS Electronic manufacture service 电子制造服务FA Failure Analysis 不良分析FAI First Article Inspection 首件检验FIFO First In First Out 先进先出FPYR First Pass Yield Rate 直通率FMEA Failure Mode Effect Analysis 失效模式影响分析FQA Final Quality Assurance 最终品质保证IPQC In Process Quality Control 制程品质管制IQC Incoming Quality Control 进料品质管制IFIR Initial Field Incident Rate 初期市场不良率JQE Joint Quality Engineer 共同品质工程师KPI Key Performance Indication 关键业绩指标LRR Lot Reject Rate 批退率LSL Low Specification Limit 规格下限MRB Material Review Board 材料审核会议MSA Measurement System Analysis 测量系统分析ME Manufacturing Engineering 制造工程NCM Non-Conformance Material 不合格品N/A None Available 不合适，不适用NG No Good 不良品NPL Non-Production Loss 非生产漏失ORT On Reliability Test 可靠性测试OQC Outgoing Quality Control 出货品质管制OEM Original equipment manufacturer 原设备制造者ODM Original Design Manufacturer 原设计制造者OBA Out of Box Audit 开箱检查PCB Printed Circuit Board 印刷电路