摄像（Camera）.doc

摄像（Camera） Camera driver, manual installation Connect the camera to the computers valid USB interface, and the system will prompt for new hardware and pop up the product installation wizard Follow the directions: Click next Follow the prompts to search for the latest drivers. Click next: Specify the location of the driver corresponding to the product type: product model see the package, bar code, the last few, such as FL-309PI, please put the drive batch to the 309 directory in the cd: Click next to complete the product driver installation: Note: in the process of product driven automatic or manual installation, please click continue installation as shown in this drawing Using the relevant video software, you can see the picture of the camera! 3. solutions that cannot be displayed normally: After the A. installation driver, you will see PC Camera in the start - program of WINDOWS, and there is a Amcap program that can adjust the effect and settings of the camera immediately. If the runtime appears as follows: It means that your camera may not be connected to a computer or drive is not installed! The following steps are checked: On the desktop, my computer icon right click, select properties, appear computer Properties screen, point device manager, appear the following picture: If shown above, it shows that you do not have a camera attached and insert the camera into the computer USB interface The figure above is in the normal state, and the product name is visible in the device manager! If such a picture appears, the camera driver has not completed the installation, you can try to automatically install the driver, or manual installation: select the device, point below the property, the product property interface appears! Click reinstall driver: The following can refer to manually install the camera method, complete the drive installation process: B: if you use the AMCAP software to view the image as shown below, and in the device manager can also display normally: P