How to Install metal lath CS Stucco Plaster（如何安装金属板条 CS灰泥和石膏）.pdf

How to Install metal lath These installation recommendations are intended to be instruc- undue sagging. Then self-furring lath is installed over sheathing or tional and accurate. This is first a guideline, providing a general solid surface, the maximum spacing of supports maybe 24” on center. overview and also equips the new steel lather with specific instal- *Note: Lath shall be furred away from vertical supports or solid sur- lation details, based on ASTM C 1063-99 Standard Specification faces at least ¼”. Self-furring lath “dimples” “V-grooved” or “ribbed” for Installation of Metal Lath. lath meets these furring requirements. See chart “Support Spacing for Always consult your area building official before beginning any project Metal Lath” on page 3 (Rib Lath). to familiarize yourself with any local code requirements. This guide should not replace the designs and judgments of a qualified engineer Cut and Trim to Fit and/or architect. Standard sheet shears or metal cutting scissors are effectively used for notching and snipping. A conventional circular saw equipped with a met- Lath Installation al cutting blade easily zips through steel lath to cut to desired lengths. Begin at the right hand bottom corner of the wall. If paper backing behind the lath is required, leave the paper over hanging at the top and Wire Tie to the left of the sheet. Offset paper backing has the paper overlap-