avaya交换机命令大全（Avaya switch command Daquan）.doc

avaya交换机命令大全（Avaya switch command Daquan） Understand the Avaya switch command, but you can easily master and use the Avaya switch. P334T-ML Avaya switch command Daquan Avaya switch basic settings: Configuration switch The P334T-ML Avaya switches can be edited using text command lines, and the 330 series can be managed with support, web administration, or MSNM. The default settings for the P334T-ML Avaya switch are as follows: IP address: 34 Subnet mask: Default gateway: Manage VLAN number: 1 Spanning tree: enabled Username / password: root You can configure the consle port by using RJ-45 to convert the BD-9 terminal line. Configure the IP address of the P334T-ML Avaya switch Use the super terminal to connect the switches Enter user name and password: root Enter command: set interface inband Press the Enter key to confirm Enter reset to restart the device Enter set IP route to set the default gateway Configure the initial routing parameters of the P334T-ML Enter set device-mode router and press enter to confirm Enter Y to restart the device Enter show device-mode to ensure that the device is running within the routing mode Enter session router to enter the three layer mode Enter configure to enter configuration mode Enter the command set VLAN name to configure the three layer VLAN Enter command interface to enter port configuration mode Enter the command IP address to set the IP address and subnet mask Enter the command exit to exit the port configuration mode Enter the command IP default-gateway to set the default gateway Enter the command copy running-config startup-config to save the settings All two layers command: The 1. Session is used to open a session or conversion mode The syntax of the command Session [[switch router ATM mpg | | | | wan]] The default number is the first switch if the number of mod_num switches is not specified. The 2. Terminal is used to define the height and width of characters displayed on the screen The syntax of the command Terminal {